Altronix NetWay16M Installation Guide download pdf (Page 3)

NetWay8M/NetWay16M - 3 -

Fig. 1

1a OUT1-8(NetWay8M),OUT1-16(NetWay16M):StructuredcabletoPoEcompliantcameras/edgedevices.

1b IN1-8(NetWay8M),IN1-16(NetWay16M):Structuredcabletoethernetswitchorvideoserver.

1c LED(s)1-8(NetWay8M),1-16(NetWay16M):PortstatusLEDs.

1d Reset:Restoresunittofactorysettings.

1e +---,PoEShutdown:Lowvoltagetriggerinput(see Technical Specifications pg. 5).

1f Ethernet:LANorlaptopconnectionenablesNetWayMprogrammingandstatusmonitoring.

AC POWER

NetWay8M & NetWay16M - Rear Panel

NetWay8M - Front Panel

NetWay16M - Front Panel

+ PoE --

SHUTDOWN

+ PoE --

SHUTDOWN

1e 1f

Note: AllinterconnecteddevicesmustbeULListed.

7. UponcompletionofwiringsetilluminatedmasterpowerdisconnectcircuitbreakertotheRESET(ON)

position (Fig. 1g, pg. 3).

8. PortstatusLEDsontheNetWayMwillinitializewhenPoEdevicesareconnectedasfollows:

 - LEDwillilluminatewhendevicesareIEEE802.3afcompliant.

 - LEDwillblinkonceandilluminatewhendevicesareIEEE802.3atcompliant(PoEPlus).

9. To utilize the PoE shutdown feature it is necessary to do the following:

a. Connect a device that will provide a low voltage trigger input (see Technical Specifications pg. 5) to terminals

  marked[+---,PoEShutdown]ontheNetWayM(Fig. 1e, pg. 2). When voltage is applied, the PoE shutdown

  enabledPoEport(s)willdroptozerovolts.Removingthelowvoltagetriggerinputatthe[+---,PoEshutdown]

terminals will allow the PoE port(s) to operate normally and supply power to PoE compliant devices. Power will

  resetinapproximately4seconds.AlthoughthereisnooutputvoltagetopowerPoEdevicesduringshutdown,data

signals may still be present on the data pair lines of the structured cable.

b. Individual ports must be programmed utilizing the user interface (see User Interface and Programming, pgs. 6 & 7).

Port Status and LED Flash Codes:

Port Status Flash Codes Description

AllPortsOff SequentialLEDPortScan No devices connected

PortOff OFF LEDOFF

PortOn ON LEDON

Class4detectionPort Blinks2times Enables power to PoE devices.

Non-compliantDevice 2Hz Will prevent port from turning on.

PortOverloadFault 5Hz Will prevent port from turning on.

4PortOverloadGrouped 5Hz 4LEDs

Will prevent ports from turning on.

8PortOverloadGrouped 5Hz

LED’s1-8PowerSupplyOverloadforports1-8.

LED’s9-16PowerSupplyOverloadforports9-16.

1 2 3 4 5 6 7 8 ... 11 12

Comments to this Manuals

No comments

Altronix NetWay16M Installation Guide Page 3

Comments to this Manuals